7 minutes to recover from WLC 5760 HA to primary WLC 5760
Considering the following scenario:
Both WLC are in the same subnet and running IOS XE 03.03.01SE
- In the Configuration->Wireless->Global AP Configuration we've configured the "Global AP Failover Priority" + "Back-up Primary Controller IP Address" + "Back-up Primary Controller Name" + "Back-up Secondary Controller IP Address" + "Back-up Secondary Controller Name" in both WLCs.
- Configured the primary and secondary IP address in all APs
- From a total of 47 APs, we've configured 8 of them with priority Critical, 7 APs with priority High and 3 APs with priority Medium.
We've issued an reload to the primary WLC and it took 7 minutes for the APs recover from the Secondary to the Primary
13:14 - reload issued on the primary WLC
13:15 - service granted by the secondary WLC (required an shut/no shut to the "Network Status" of the radio interfaces)
13:22 - service recovered to the primary WLC
The priority values mentioned above didn't show much improvement in the AP recovery time.
Is 7 minutes a normal recovery time for the 5760 WLC?
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 22.214.171.124, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...