I've been searching the forums and product data sheets, release notes etc... but I can't seam to work out what is the current definative documetns I should be reading to
- A setup the WLC to ensure I have the correct requirements for the 7925g handsets
I have read documents on 7925gs needs and have 20% overlap of signal strength etc.. I have walked the site with 3 handsets on site survey mode and at any time the all have about -58 to -67 from multiple AP's. Tried A freq and similar results of call audio loss.
I have read documents re various WLC's 5508 4400 2100 etc.. regarding QOS, WPA and roaming, but I still get an issue of rubbish roaming with about 3sec audio cutoff of voice between AP's and then call returns.
A little about the site:
- 17 1142 AP's
- 2504 WLC running 22.214.171.124
- 13 7925g handsets running 126.96.36.199
- 10 7600 series wired handsets (which work without fault)
- 1 x UC560 running 8.6
No radius server. I even set the SSID to no security in an attempt to verify raoming, but appears this makes no difference.
Ive setup the 2100's and never had a problem.
Any pointers or documents I should be reading or a deffinative "set to this config" would be appreciated.
This event was scheduled for September 23rd, but it has been moved to November 10 due to complex and unexpected circumstances. We apologize for all the issues this may cause.
Community Live- All Things LTE…4G, 5G and Whatever’s Next
(Live event - formerly...
Hello i have acces point 1815i cisco and we want installed in entreprise and we have camera surveillance wireless cisco so i want to know how much distance between ap 1815i and camera surveillance wi...
We want to broadcast a SSID (and allow users to connect) between certain times each day, and then take it offline. Unfortunately we dont have prime and only DNA Essential Smart licencing. All documents that I am seeing is that its possible if you have pri...
Hi all,I am looking for some guidance here, and I am quite certain that some of you, great minds, will be able to stir me in the right direction here. And a big thanks in advance. Here we go, i have three sites connected over private link MPLS....
Hi to all I purchase new AP C9120AXE converted to EWC.I notice when AP is booting a message related to default route not set that it says that can affect performance.Message is : %Default route without gateway, if not a point-to-point interface,...