I've been searching the forums and product data sheets, release notes etc... but I can't seam to work out what is the current definative documetns I should be reading to
- A setup the WLC to ensure I have the correct requirements for the 7925g handsets
I have read documents on 7925gs needs and have 20% overlap of signal strength etc.. I have walked the site with 3 handsets on site survey mode and at any time the all have about -58 to -67 from multiple AP's. Tried A freq and similar results of call audio loss.
I have read documents re various WLC's 5508 4400 2100 etc.. regarding QOS, WPA and roaming, but I still get an issue of rubbish roaming with about 3sec audio cutoff of voice between AP's and then call returns.
A little about the site:
- 17 1142 AP's
- 2504 WLC running 18.104.22.168
- 13 7925g handsets running 22.214.171.124
- 10 7600 series wired handsets (which work without fault)
- 1 x UC560 running 8.6
No radius server. I even set the SSID to no security in an attempt to verify raoming, but appears this makes no difference.
Ive setup the 2100's and never had a problem.
Any pointers or documents I should be reading or a deffinative "set to this config" would be appreciated.
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 126.96.36.199, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...