802.1X support for Windows Embedded Handheld 6.5 or Windows CE 6.0
I've purchased the Datalogic Falcon X3 scanning device and trying to workout the best wireless authentication method for the devices. The device is running Window Embedded Handheld 6.5 or Windows 6.0 Operating system.
Has anyone configured these devices or similar to use 802.1X authentication? I read the post below which states there might not be a suitable EAP client installed on the device to use EAP-TLS.
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?