cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
235
Views
0
Helpful
3
Replies
Highlighted
Beginner

8510 WLC realase 8.1 New mobility?

Hi,

 

Does someone know when the release 8.1 for the 8510 WLC is coming? Does it going to support the New Mobility stuff? As far as I know, Cisco was planning to include this feature back again in version 8.1.

 

Thank you.

 

Joana.

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

We have a 8510 WLC as a

We have a 8510 WLC as a foreign controller and a 5760 as a mobility anchor in the DMZ. Will this be supported?

Yes, Guest anchoring will be supported between 8510 with new mobility & 5760

We have been advised to use 2504 WLCs as mobility anchors for smaller sites. Do you think they will interoperate fine with our core/foreign 8510 WLCs?

I would think so. 2504 with new mobility, you should be able to peer it with 8510.

 

HTH

Rasika

*** Pls rate all useful responses ****

View solution in original post

3 REPLIES 3
Highlighted
VIP Mentor

I believe 8.1 coming in late

I believe 8.1 coming in late April or early May.

Yes, new mobility will be there. But if you are hoping to put 5508/WiSM2/8510 as MC for 3850/3650 MA, that won't be feasible. Cisco has dropped MC functionality on these platforms starting on 8.1 code. So if you require dedicated MC, then it has to be 5760.

 

Still once you enable new mobility on 5508/WiSM2/8510, you can peer it with a 5760. So roaming will work between converged access & centralized (5508/WiSM2/8510) in mixed deployment.

 

HTH

Rasika

**** Pls rate all useful responses ****

 

Highlighted
Beginner

Hi,Ok, not too far then.We

Hi,

Ok, not too far then.

We have a 8510 WLC as a foreign controller and a 5760 as a mobility anchor in the DMZ. Will this be supported?

We have been advised to use 2504 WLCs as mobility anchors for smaller sites. Do you think they will interoperate fine with our core/foreign 8510 WLCs?

Thank you for your response.

Joana.

Highlighted
VIP Mentor

We have a 8510 WLC as a

We have a 8510 WLC as a foreign controller and a 5760 as a mobility anchor in the DMZ. Will this be supported?

Yes, Guest anchoring will be supported between 8510 with new mobility & 5760

We have been advised to use 2504 WLCs as mobility anchors for smaller sites. Do you think they will interoperate fine with our core/foreign 8510 WLCs?

I would think so. 2504 with new mobility, you should be able to peer it with 8510.

 

HTH

Rasika

*** Pls rate all useful responses ****

View solution in original post

CreatePlease to create content
Content for Community-Ad