11-28-2015 07:16 AM - edited 07-05-2021 04:19 AM
hi
i am facing a problem with one Access point that the flash is empty without any image , the access point start in the rommon mode how i can download an image in the flash ?
what is the steps for that ??
the access point model is 1700
thanx
Solved! Go to Solution.
11-28-2015 07:57 AM
Hi,
follow this link:
https://supportforums.cisco.com/document/56156/access-point-rommon-recovery-ap-prompt-recovery-example
Regards
Dont forget to rate helpful posts
11-28-2015 07:57 AM
Hi,
follow this link:
https://supportforums.cisco.com/document/56156/access-point-rommon-recovery-ap-prompt-recovery-example
Regards
Dont forget to rate helpful posts
11-28-2015 12:34 PM
thanks
i already try these command but after step 6 nothing happened and give me message session timed out so is there a particular name for the image
ap: tar -xtract tftp://x.x.x.x/images/ ap3g2-k9w7-tar.153-3.JBB flash
this is what i try .
11-29-2015 08:41 AM
Your tftp root folder might be the issue. If the image is not in the image folder, then your path is incorrect. If the file is in the tftp root folder, then you need to remove the image/ in the file path.
Example:
ap: tar -xtract tftp://x.x.x.x/ap3g2-k9w7-tar.153-3.JBB flash
-Scott
11-29-2015 11:37 AM
Hi,
May be you need to run this command:
ap: tar -xtract tftp://x.x.x.x/images/ ap3g2-k9w7-tar.153-3.JBB.tar flash
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide