cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

420
Views
0
Helpful
2
Replies
Beginner

Add new access points automatically in FlexConnect mode

Hi all,

 

I have to setup several new Wifi environments with a lot of APs and 3504s. All APs should work in FlexConnect Mode. When I connect a new AP to the network the whole config comes from the controller except FlexConnect mode. So I have to configure all APs on all controllers manually to FlexConnect mode? For a few hundred APs?

 

Is there any feature or command to save a lot of time and work?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Mentor

Re: Add new access points automatically in FlexConnect mode

You can do it via WLC CLI:

 

check this post:

 

https://www.freerkterpstra.nl/2014/09/19/convert-new-access-points-automatically-to-flex-connect-mode/

 

Regards

Dont forget to rate helpful posts

View solution in original post

2 REPLIES 2
VIP Mentor

Re: Add new access points automatically in FlexConnect mode

You can do it via WLC CLI:

 

check this post:

 

https://www.freerkterpstra.nl/2014/09/19/convert-new-access-points-automatically-to-flex-connect-mode/

 

Regards

Dont forget to rate helpful posts

View solution in original post

Highlighted

Re: Add new access points automatically in FlexConnect mode

You can use the command config ap mode flexconnect submode none <APName/MACAddress>

 

 

 

 

 

Regards,
Sathiyanarayanan Ravindran

Please rate the post and accept as solution, if my response satisfied your question:)
CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards