04-24-2019 11:57 PM - edited 07-05-2021 10:17 AM
Hi all,
I have to setup several new Wifi environments with a lot of APs and 3504s. All APs should work in FlexConnect Mode. When I connect a new AP to the network the whole config comes from the controller except FlexConnect mode. So I have to configure all APs on all controllers manually to FlexConnect mode? For a few hundred APs?
Is there any feature or command to save a lot of time and work?
Solved! Go to Solution.
04-25-2019 05:20 AM
You can do it via WLC CLI:
check this post:
Regards
Dont forget to rate helpful posts
04-25-2019 05:20 AM
You can do it via WLC CLI:
check this post:
Regards
Dont forget to rate helpful posts
05-07-2019 07:11 AM
You can use the command config ap mode flexconnect submode none <APName/MACAddress>
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide