06-17-2019 08:12 AM - edited 07-05-2021 10:34 AM
I brought a used AIR-AP2802I-E-K9, I plugged it in and it didn't work so i purchased a power injector. I have now got it to power up. After it finished its little boot the leds flash green red and blue constantly. The SSID isn't visible. Could this be reset to factory settings?
Thanks in advance
06-17-2019 08:24 AM
Here is a document that goes over the led status: https://www.cisco.com/c/en/us/td/docs/wireless/access_point/2800/quick/guide/ap2800iegetstart.html#pgfId-69305
What you should do is console into the ap and see what the output is showing you.
06-17-2019 09:23 AM
06-18-2019 12:53 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: