air ap2802i-e-k9

[Mady Gueye]

Hello,

Erroe from my new ap2802i-e-k9

see attach.

Regards,

[Sandeep Choudhary]

Hi,

The settings in the Hyper Terminal/or Others need to be set correctly; otherwise, "strange-looking" or garbage characters may show up on the screen(As your output in attached file). When you set up the connection, use these settings and try again:

Bits per sec : 9600
Data bits : 8
Parity : none
Stop bits : 1
Flow control : none

Regards

Dont forget to rate helpful posts

[Mady Gueye]

thanks you for your answer,

i do that but still same

[Sandeep Choudhary]

try to change the baud rate ex: 2400, 4800...., 115200  and check again.

[Mady Gueye]

stiil same but another new ap2802i-e-k9, all is ok

[patoberli]

Either somebody changed the BAUD rate of it, or it's broken.

[Mady Gueye]

it's a new AP.

what i do to solve?

[patoberli]

If the same settings work for another AP and only not this one, I would return it, marked as "dead on arrival". You maybe need to do an RMA process, check with your reseller.

[Mady Gueye]

thank you, i will process to RMA case.

regards,