I just want to Know how many users can connect to AIR-CAP3602I-x-K9 at singel point of time.
This depends on a number of factors. As what Scott has mentioned, the rule-of-thumb is 25 clients per WAP. But this number can go up or down depending on the type of traffic you plan to push. If, for example, you're going to say you're pushing nothing but emails,HTTP/HTTPS, etc. then this number may as well go up to 35. However, if you plan to start pushing video then this number could potentially go down to 8 clients per WAP.
Now, take note that we are talking about 802.11a/n for video. If you bring into the picture 802.11b clients then you may as well don't bother trying.
Another thing is the type of ethernet uplink you are trying to do. I remembered reading someone trying to push 802.11n but using only a 2500 and his LAN switch is a non-gigethernet uplink to the WAP.
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 126.96.36.199, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...