04-08-2009 05:16 AM - edited 07-03-2021 05:25 PM
Hi,
I have 4500-E serial Catalyst Switch and AP1252AG access point.
WS-X4248-RJ45V (48 Port PoE Card) is installed in 4500-E switch and access point is connected with this switch without power injector. But i am getting LOW power error in AP. AP have 3 radios (2.4 GHz). I have tested with 1 radio also but still i have same problem.
Can you please guide me to solve this problem ?
What power command i have to apply on switch port and AP interface.
Its very urgent please...
Solved! Go to Solution.
04-08-2009 05:43 AM
Hi Prashant,
From Steve @ Cisco;
Information on the 4500 supporting the 1252 is below:
4500 modules req switch to run 12.2(44)SG or later
WS-X4648-RJ45V-E
WS-X4648-RJ45V+E
power inline port maximum 20000
power inline auto max
From this excellent thread;
Hope this helps!
Rob
04-08-2009 05:43 AM
Hi Prashant,
From Steve @ Cisco;
Information on the 4500 supporting the 1252 is below:
4500 modules req switch to run 12.2(44)SG or later
WS-X4648-RJ45V-E
WS-X4648-RJ45V+E
power inline port maximum 20000
power inline auto max
From this excellent thread;
Hope this helps!
Rob
04-08-2009 10:02 PM
Dear Rob,
Thanks for immidiate reply. I will make change as per your recommendation.
Prashant
04-08-2009 02:59 PM
If you are running Autonomous image, follow Rob's suggestion. If it's LWAP, then upgrade the controller to the 5.2.X firmware and it will work but with lower power output.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide