Hi,
I am trying to use my AP with my cable modem. I have upgraded to the proper ios but am still running to a issue. Ideally, I want the AP connected to the cable modem and client would connect to the AP, get an IP and be able to surf the web. Right now, the ap is the only device that gets an IP from the modem (Moto sb5120). How can I enable: (1) the AP to act as a dhcp server and (2) forward web traffic to the modem?
Here is the conf. from the AP. I erased the changes I made during testing. Any help will be appreciated.
----------
c1130-k9w7-mx.124-10b.JDA/c1130-k9w7-mx.124-10b.JDA
Cisco IOS Software, C1130 Software (C1130-K9W7-M), Version 12.4(10b)JDA
cisco AIR-LAP1131AG-A-K9
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname ap
!
enable secret 5 $1$Z7vP$0TTz8a2ezkxhzmxkHsSyt/
!
no aaa new-model
!
!
power inline negotiation prestandard source
!
!
username Cisco password 7 123A0C041104
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface Dot11Radio1
no ip address
no ip route-cache
dfs band 3 block
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface FastEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address dhcp client-id FastEthernet0
no ip route-cache
!
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
login local
!
