I'm trying to use vlan tagging for the AP-2602 access port to join the WLC.
VLAN-Tagging is enabled for the AP (WLC setting) and the switchport as tunk.
AP won't access the right VLAN.
Work when I change the switchport to access-mode, access vlan xx.
VLAN-tagging Works for the AP 2700 version.
Can it be that AP's 2800/1800 do not support the vlan tagging?
AP are in local or flexconnect mode ?
If the AP is in local mode, the switch's port is in access mode no matter how many ssid are managed by the AP. All the trafic go in the CAPWAP tunnel
If the LAP is in HREAP/Flexconnect mode, the switch's port is in trunk mode.
H-REAP allows to swtich some wlans locally, that's why a trunk port is necessary on the switch.
Dont forget to rate helpful posts
The AP is in local mode.
I know that the AP need's only one vlan to connect with the wlc.
As the AP's area are not secure, I want to tagging the "access-vlan" from AP view.
E.g. somebody diconnect the AP network cable an put the laptop on it, it will connect to an "empty" vlan (the native one). When the AP is connected, it tagges the "right" vlan to get connected with the wlc.
This setup worked for AP 2700.