AP detail information

[lenkasurat]

Hello Experts,

Wireless controller summary page displays the AP & radio 0 & 1 up/down status.

Is there an easy way to find the AP which is affected?

Right now I have to go through all the AP's and see the status.

Your idea & suggestions will be highly appreciated.

Thanks in advance,

[Freerk Terpstra]

I can think of three possible solutions for this:
1. If all of your AP's have CleanAir enabled you can filter on "CleanAir Oper Status" in the web GUI
2. Use the following command on the CLI:

(WLC) >grep include "DOWN" "show advanced 802.11a sum"

3. Use Cisco Prime Infrastructure as monitoring tooling

Please rate useful posts :-)

[lenkasurat]

Thank you very much Freerk,

In my environment we have many APs 1242 model so clean air is not available.

and this is the output of the command & one AP radio1 is down.

Thanks again in advance for any explanation. what I understand is this commands output will also depend on clean air enabled APs only, please correct me if, I am right.

[Freerk Terpstra]

The command is case-sensitive, so it needs to be "DOWN" instead of "down". You don't need CleanAir access-points for getting the correct output with this command.

Please rate useful posts :-)

[lenkasurat]

Thank you very much Freerk!!

It worked and very useful command.

Thanks!!

[Sandeep Choudhary]

HI Lenka,

As per your screenshot, your 5 APs Slot1 (5Ghz) is down.

and you want to know that which AP having this problem right ?

Go to Wireless > Access Points>Radios >802.11a

Here you will see the complete list of APs with Radio status.

See the screenshot:

Regards

Don't forget to rate helpful posts