cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
590
Views
0
Helpful
5
Replies

AP1702i does not join WLC5520

kuweb
Level 1
Level 1

Hello I have a problem to join a 1702i AP to the 5520 controller. I have attached the debug capwap and the console output of the AP.

On the Controller runs the newest SW Release 8.3.102

Has anyone an idea whats the problem?

Thanks for your help

5 Replies 5

Leo Laohoo
Hall of Fame
Hall of Fame
Unknown AP type. Using Controller Version!!!

CSCuy50490

Hi Leo

I saw this bug, and I installed the newest (fixed) version 8.3.102. But it doesn't work

which country did you configure on WLC ?

Make sure the time is set properly on the WLC and also make sure the country code for the APs are set on the WLC.

Regards

Hi Sandeep

On the controller I configured CH - Switzerland and the AP is AIR-CAP1702I-E-K9 that should be o.k.

yes regulatory domain is ok.

Did you set the time correctly ? also try to reboot WLC!!!

if still fail then use any other software...

Regards

Review Cisco Networking products for a $25 gift card