APs controller assigning wireless clients ip addresses that are off of the APs subnet
I am having an issue with wireless controler assigning wireless clients ip addresses that are off of the associated access point’s subnet.
We have a Cisco 5500 Series wireless controller on our 192.168.0.0 LAN
We have 3 subnets all of which have access points 220.127.116.11, 18.104.22.168, and 22.214.171.124.
All access points have static ips and are configured the match their respective subnets and connected to the switch within their subnet.
When any wireless client connects to an access point within the subnet the client is automatically assigned a 192.168.x.x ip address of the lan and is not given an ip address with in the subnet. However, the client see the 192.165.x.x (subnet router interface) as it’s gateway.
I have searched and cannot figure out why the wireless clients are not being assigned ip address on the subnet of which the associated access point is attached.
I have:Product/Model Number : AIR-SAP1602I-E-K9withCisco IOS Software, C1600 Software (AP1G2-K9W7-M), Version 15.3(3)JC, RELEASE SOFTWARE (fc1)I need to have internet access via eth in a deep place of my basement. So I bought a small thing called wifi ext...
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...