I'm having problem with ASA 5510 and WLC 526, in this case the ASA provides DHCP, I created 3 vlan's (12 administrative, 13 visits, 10 AP's). WLC 526 has two network interface, eth0 in this vlan 10, and eth1 is in a TRUNK port on the switch in valn 12 and 13. The fact is that when a user attempts to connect to wireless network does not take DHCP, but setting a fixed ip connection works perfectly.
One problem is that the WLC has 526 limited-config below.
These commands available:
(Cisco Controller)> config?
Advanced Advanced Configuration.
(Cisco Controller)> config advanced?
802.11a 802.11a parameters.
802.11b 802.11b parameters.
Auto client-handoff handoff clients on the excessive retires.
dot11-Set padding over-the-air frame padding
eap EAP (Extensible Authentication Protocol) Settings
macfiltering macfilter Configure advanced settings.
max-1x-sessions Maximum 802.1x session initiation per AP at the time.
probe-limit limit number of probes to sit AP per switch slot per client in a Given interval.
rate Enable / Disable switch control path rate limiting.
Statistics Enable / Disable switch port statistics.
Configures timers, system timers.
Mini IOS Version 3.0.51.0 .............................
........................... IOS Version 12.4 (10b) JX
Attached below the debug WLC dhcp message, and runnig config.
Thanks
