Autonomous AP Configuration

[stephen.bel0001]

Can some one help me with the best practice or document  for Autonomous AP and Bridge Configuration
 

[Prakash Parvathala · Accepted solution]

Please go through the below link.

https://supportforums.cisco.com/document/61936/autonomous-ap-and-bridge-basic-configuration-template

[stephen.bel0001]

Thank you Prakash,
 

it helped me

[Sandeep Choudhary · Accepted solution]

Hi Stephan,

Check this out:

For AAP conifguration: https://rscciew.wordpress.com/category/autonoumous-ap/

For Bridge conifguration: https://rscciew.wordpress.com/2014/10/26/autonomous-ap-as-wireless-bridge/

Regards

Dont forget to rate helpful posts

[Moin Ilyas]

Please check the following links:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap5-admin.html

http://mrncciew.com/2013/01/13/autonoumous-ap-wireless-bridges/

[mohanak]

The 1300 series access point/bridge assumes a radio network role of a root access point. To configure it as a bridge, you must manually place it in install mode in order to align the antennas and establish a link. To establish the link you must have two access point/bridges configured in the install mode. In the install mode, one access point/bridge must be configured as a root bridge and the other a non-root bridge. To facilitate the configuration, an automatic option is available when the access point/bridge is in the install mode. After the wireless link is established and the bridge antennas are aligned, you take both access point/bridges out of install mode and place them on your LAN as root and non-root bridges.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap4-first.html