cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1211
Views
0
Helpful
3
Replies
Highlighted
Enthusiast

Bandwidth Requirements for Remote WLC w/ HREAP

Hello, I am looking at deploying a 5500 WLC for about 80 remote sites with 1242 APs to connect to using HREAP. Some of these sites have a 512k link, but they are not heavily utilized. I was just wondering if anyone had some tips or had experience (good or bad) with deploying this scenario using low bandwidth links. Currently the sites are using autonomous APs with a WLSE for management....I want to move away from that. Thanks in advance.

Everyone's tags (4)
3 REPLIES 3

Re: Bandwidth Requirements for Remote WLC w/ HREAP

Well, I think the HREAP deployment guide has some guidlines as to what the required bandwidth is.  IIRC it's 128k minimum, and each AP can hit something like 32kbps.  Since you're going to go HREAP, it shouldn't be too bad on the link, as all the real traffic will be localized, and only the AAA/Webauth and AP management stuff will go across the link.

HREAP Design and Deployment Guide

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Cisco Employee

Re: Bandwidth Requirements for Remote WLC w/ HREAP

here is the link which answeres ur question, please go through the link coz its the Design and requirements for HREAP!!

http://www.cisco.com/en/US/products/ps6087/products_tech_note09186a0080736123.shtml

Lemme know if this answered ur question!!

Regards

Surendra

Regards
Surendra BG
Enthusiast

Re: Bandwidth Requirements for Remote WLC w/ HREAP

Thanks for the replies. Yes, I am familiar with the design guide, I was just looking to see if anyone had been involved with an actual implementation similar to what I had described, and had thoughts to share on it.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards