I just purchased an AIR-SAP2602e, with Smartnet Service Contract. It's on the network, running
System Software Filename: ap3g2-k9w7-xx.152-2.JA System Software Version: 15.2(2)JA Bootloader Version: BOOTLDR: C3600 Boot Loader (AP3G2-BOOT-M) LoaderVersion 12.4(25e)JAY, RELEASE SOFTWARE (fc1)
The Online help file is still pointing to a IOS release running my previous AP1252AG, software c1250-k9w7-tar.124-25d.JA.tar. The AP1252AG now is completely disconnected from the network.
I have tried pointing the help file to the version corresponding to the new AP software, following Cisco instructions, with no success. Can someone either point me to a known working procedure, or reveal the secret I'm consistently missing?
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...