Can the 1562E act as an ethernet passthrough like the 1552 could

[Travis-Fleming]

We are looking to deploy another 1562E-B-K9 to a light pole in the middle of a parking lot. We will have a multi-mode fiber running and street light providing power to the device, leaving the Ethernet port open.

Is it possible then to use the vacant Ethernet port as a pass-through or switch if we also wanted to have it power a PoE IP Camera on the same pole?

[marce1000 · Accepted solution]

                                                          - Looks like not , ref : https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1560/installation/guide/1560hig/1560_ch1.html

 >...

^1.Either the SFP port or the Gigabit Ethernet port can be used as the uplink port, However, if the SFP port is in use, then the Ethernet port cannot be used as a local client port.

 M.