cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

417
Views
0
Helpful
3
Replies
Highlighted
Beginner

Central WebAuth WLC with local switching

Hi Guys,

I am trying to configure a guest WLAN using central WebAuth via Controller SplashPage and after succesfull Authentication local switching in the remote sites Guest WLAN/VLAN.

 

- Using Flexconnect I connected the remote AP to the WLC and set its mode to Flexconnect.

- SSID is configured with L3 Security Web Policy Authentication.

- FlexConnect Tab on AP Settings is set to VLAN Support with native VLAN (103 management VLAN) and the mapping then set to the remote sites guest VLAN (104).

- at the remote site the client can reach a dhcp server in VLAN 104.

 

Now if I connect a client to the remote guest WLAN it does not get an IP. Do I need to set something else in the settings?

Is this scenario possible to configure and supported?

 

Thanks in advance!

3 REPLIES 3
Hall of Fame Master

Re: Central WebAuth WLC with local switching

Did you create a trunk port from the AP to the switch and verify the vlan the guest are suppose to be on  is forwarding?  Is that vlan 104?

-Scott
*** Please rate helpful posts ***
Beginner

Re: Central WebAuth WLC with local switching

Yes AP is connected to a trunk Port with the remote guest VLAN (104) and the native/management VLAN.

Cisco Employee

Re: Central WebAuth WLC with local switching

To isolate create open-ssid and check.
CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards