10-23-2019 08:01 AM - edited 07-05-2021 11:11 AM
Hello,
I have a Cisco 3702i setup in autonomous mode that has been running for a few weeks. I can SSH into it using my new username and password, but can't use this to log into the GUI I have to use the default of Cisco:Cisco, it seems to be the only one that will work on the GUI.
What do I need to do to remove the default username and password and create a new one for GUI access?
Thanks
Solved! Go to Solution.
10-23-2019 04:47 PM - edited 10-24-2019 02:57 PM
Hi Andrew,
IT expect enable password. So try your new username with enable password combination. That should work (by default exec & enable password both are "Cisco", hence confusing)
HTH
Rasika
**** Pls rate all useful responses ***
10-23-2019 04:47 PM - edited 10-24-2019 02:57 PM
Hi Andrew,
IT expect enable password. So try your new username with enable password combination. That should work (by default exec & enable password both are "Cisco", hence confusing)
HTH
Rasika
**** Pls rate all useful responses ***
10-24-2019 05:53 AM
Ah yes that worked, very confusing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: