cisco 1700 Access Point standalone

[VIVIDHA IT SOLUTIONS INDIA PVT LTD]

Hello

I am using 10 number access points 1702i Autonomous AP IOS Software-15.3.3-JF1(ED),

ISP broad band is 100 mbps  when i was connected to ap it is show 15 to 20 mbps and when was connected  LAN speed is 90 to 98 mbps 

cloud any one help us regarding this problem i am going on trying not able to find solution

[Sandeep Choudhary]

1. Are you using WPA2 with AES

2. WMM is enabled or not ?

can you paste the config of the AP.

Regards

Dont forget to rate helpful posts

[VIVIDHA IT SOLUTIONS INDIA PVT LTD]

Hi, Please find the configuration of AP sh run Building configuration... Current configuration : 2000 bytes ! ! Last configuration change at 00:24:57 UTC Mon Mar 1 1993 version 15.3 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname ap ! ! logging rate-limit console 9 enable secret 5 $1$JIgy$kZHL0rQeC0o6DfBWV6xhU0 ! no aaa new-model no ip source-route no ip cef ! ! ! ! dot11 pause-time 100 dot11 syslog ! dot11 ssid APDMG authentication open authentication key-management wpa version 2 guest-mode wpa-psk ascii 7 0207145F06012F701E1D ! ! ! no ipv6 cef ! ! username Cisco password 7 123A0C041104 ! ! bridge irb ! ! ! interface Dot11Radio0 no ip address encryption mode ciphers aes-ccm ! ssid APDMG ! antenna gain 0 stbc station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding no shut ! interface Dot11Radio1 no ip address ! encryption mode ciphers aes-ccm ! ssid APDMG ! antenna gain 0 peakdetect no dfs band block stbc channel dfs station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding no shut ! interface GigabitEthernet0 no ip address duplex auto speed auto bridge-group 1 bridge-group 1 spanning-disabled no bridge-group 1 source-learning ! interface GigabitEthernet1 no ip address duplex auto speed auto bridge-group 1 bridge-group 1 spanning-disabled no bridge-group 1 source-learning ! interface BVI1 ip address 192.168.0.220 255.255.255.0 no shut ipv6 address dhcp ipv6 address autoconfig ipv6 enable ! ip forward-protocol nd ip http server no ip http secure-server ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag ! ! bridge 1 route ip ! ! ! line con 0 line vty 0 4 login local transport input all ! end

[VIVIDHA IT SOLUTIONS INDIA PVT LTD]

Hi,

Please find the attached sh run config of AP.