I'm doing a deployment w/ a 2504 and a few vlans. The primary SSID used by staff is on the same subnet as the hard-wired printers and they are able to see the printers w/o any issue. There is also a secondary SSID that staff uses (different subnet) that is unable to see the printers. I have multicast enabled w/ an address of 22.214.171.124, multicast ap mode is multicast, broadcast forwarding is disabled. The secondary SSID has the multicast vlan enabled and is set to the interface of the primary staff subnet for this feature. The controller is running 126.96.36.199 software so I don't have the mDNS profiles available. I know bonjour isn't routable, but I thought this setup would use the multicast vlan interface for the traffic so allow the networks to talk to each other?
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...