Deployed new WLC 2504 and when clients connect for the first time they take for ever to get an IPv4 address. On the controller the connected client has an IPv6 address initially for a while, then it finally flips over to IPv4. Is there a setting I'm missing to speed this up?
Hi, I have installed newest version of firmware on Aironet AP1832i. I noticed some issues on android devices connecting to access points. Since it is not only 1 device on 1 location but on several of them and various access points (of same type AP183...
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...