I have 3 Cisco 5508 Controllers and all 3 are setup with a redundant spare (HA). All 3 have unique names and IP addresses but I am having issues with one controller in that it's name that it was originally configured with will periodically change without any interaction and it ends up with the same name as one of the other controllers (always the same one) which cause issues.The version on the controllers is 126.96.36.199 and Prime is running 2.0
Could Prime be somehow changing the controller name and what would cause it to do that? Any suggestions is greatly appreciated
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...