I have Cisco 877, haivng low spped over inbuilt AP. I have tested it with same laptop with eccelent signal strength and qualiy.
Spped test results: UL DL
Over ethernet: 0.84Mbps 10.22Mbps
Over Wifi : 0.13Mbps 0.15Mbps
Any ideas or suggestions ?
Can you try using iperf and only testing in your local LAN. So like pc to pc then pc to wireless.
Sent from Cisco Technical Support iPhone App
When the issue occurs please capture the show dot11 asso all-clinet, also how many wireless clients are connected to the AP module at the same time the issue occurs.
We are preforming isolation test at the moment therefore wifi is not in production and connected to only 1 host.
ap#sh dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [CISCOWIFI] :
MAC Address IP address Device Name Parent State
40a6.d9f0.4a40 192.168.61.6 unknown - self Assoc
ap#sh dot11 associations all
ap#sh dot11 associations all-client
Address : 40a6.d9f0.4a40 Name : NONE
IP Address : 192.168.61.6 Interface : Dot11Radio 0
Device : unknown Software Version : NONE
CCX Version : NONE Client MFP : Off
State : Assoc Parent : self
SSID : CISCOWIFI
VLAN : 3
Hops to Infra : 1 Association Id : 1
Clients Associated: 0 Repeaters associated: 0
Tunnel Address : 0.0.0.0
Key Mgmt type : WPA PSK Encryption : TKIP
Current Rate : 54.0 Capability : WMM ShortHdr ShortSlot
Supported Rates : 54.0
Voice Rates : disabled Bandwidth : 20 MHz
Signal Strength : -56 dBm Connected for : 828 seconds
Signal to Noise : 30 dB Activity Timeout : 60 seconds
Power-save : On Last Activity : 0 seconds ago
Apsd DE AC(s) : NONE
Packets Input : 10168 Packets Output : 12868
Bytes Input : 1917377 Bytes Output : 16160162
Duplicates Rcvd : 0 Data Retries : 691
Decrypt Failed : 0 RTS Retries : 0
MIC Failed : 0 MIC Missing : 0
Packets Redirected: 0 Redirect Filtered: 0
Session timeout : 0 seconds
Reauthenticate in : never
Cisco IOS Software, AP801 Software (AP801-K9W7-M), Version 12.4(21a)JA1, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Wed 16-Sep-09 18:59 by prod_rel_team
ROM: Bootstrap program is AP801 boot loader
BOOTLDR: AP801 Boot Loader (AP801-BOOT-M) Version 12.4(23c)JX, RELEASE SOFTWARE (fc1)
ap uptime is 4 days, 6 hours, 5 minutes
System returned to ROM by power-on
System image file is "flash:/ap801-k9w7-mx.124-21a.JA1/ap801-k9w7-mx.124-21a.JA1"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
If you require further assistance please contact us by sending email to
cisco AP801GN-A-K9 (PowerPC 8343) processor (revision B0) with 49142K/16384K bytes of memory.
Processor board ID FGL15392021
PowerPC 8343 CPU at 400Mhz, revision number 0x0031
Last reset from power-on
1 Gigabit Ethernet interface
1 802.11 Radio(s)
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 64:00:F1:78:13:B8
Part Number : 73-11027-11
PCA Assembly Number : 800-28807-11
PCA Revision Number : B0
PCB Serial Number : FOC14494Y6D
Top Assembly Part Number : 800-29560-05
Top Assembly Serial Number : FGL15392021
Top Revision Number : C0
Product/Model Number : AP801GN-A-K9
Configuration register is 0xF