12-17-2012 02:21 AM - edited 07-03-2021 11:14 PM
Hi team,
I have a strange error in Cisco CISCO892W-AGN-E-K9 that i bought for our clients a month back.
- the router doesn't display the SSID for a longer period. Its like on and off of the SSID, showing sometimes and sometimes blank.
Please help with the issue.
12-17-2012 03:52 AM
Can you post the AP config. Is it different devices having issues or just one. They have within coverage.
Sent from Cisco Technical Support iPhone App
12-20-2012 12:22 AM
Hey Scott,
Please not the config below-
dot11 syslog
!
dot11 ssid NWEDC
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii 7 1102161612020003162F2A
!
!
!
username nwedc privilege 15 secret 5 $1$.SrJ$u3EVvjrMbli/I6UODVJoW.
!
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
ssid NWEDC
!
antenna gain 0
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface Dot11Radio1
no ip address
no ip route-cache
shutdown
antenna gain 0
no dfs band block
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface GigabitEthernet0
description the embedded AP GigabitEthernet 0 is an internal interface connecting AP with the host router
no ip address
no ip route-cache
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 192.168.1.10 255.255.255.0
no ip route-cache
!
!
interface wlan-ap0
description Service module interface to manage the embedded AP
ip unnumbered Vlan1
arp timeout 0
12-20-2012 12:29 AM
You need to either use WPA/TKIP or WPA2/AES. You have WPA2/TKIP and that is why. Try to change that and it should fix your issue.
Sent from Cisco Technical Support iPhone App
12-20-2012 12:31 AM
Thanks, i will try and let you know. But i do not understand what it has to do with the SSID
12-23-2012 01:42 AM
Hi Scott,
It does not work. I still have the same issue. SSID is ON and Off.
12-27-2012 11:58 AM
Hi, What is the code version the AP module is running?
12-27-2012 12:20 PM
Hi,
Can you confirm the radio interface status when the issue is reported.
Do you see any r0.core/r1.core files in "sh flash"?
Regards
Sahil
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: