I have a problem with a Cisco Aironet 1815i.
I have a Call Manager Server with DHCP and all telephones has a IP, all Pcs, but when I connect my Aironet 1815i (without config) It can't take an IP address.
I want change the access point mode to bridge, but when i want do it, it said that i haven't the name, neither mac address.
Any suggestion is appreciate!
I'm stay waiting!
Thanks a lot for your response.
Yes, It's searching for a non-existing WLC.
Now, I'm reseting the Access Point, and I'm configuring it.
It is a putty Log for the first time power on:
Management Interface IP Address: 192.168.1.1
Management Interface Netmask: 255.255.255.0
Management Interface Default Router: 192.168.1.254
Cleaning up Provisioning SSID
Create Management DHCP Scope? [yes][NO]: NO
Create Employee Network? [YES][no]: YES
Employee Network Name (SSID)?: TelefoniaIP
Employee Network Security? [PSK][enterprise]: PSK
Employee PSK Passphrase (8-63 characters)?: *********
Re-enter Employee PSK Passphrase: ********
Enable RF Parameter Optimization? [YES][no]: YES
Client Density [TYPICAL][Low][High]: TYPICAL
Traffic with Voice [NO][Yes]: NO
Configuration correct? If yes, system will save it and reset. [yes][NO]: yes
My Call Manager has DHCP. He is sending pool ip address 172.17.52.*