Cisco Outdoor Wireless Deployment Modes

[CB90021204]

Hi,

I'm looking at deploying Cisco 1552s in point to multipoint mode. I would like to know if its possible to connect wireless clients directly to the the mesh AP when in point to multipoint mode?

From the documentation (Listed below), Wireless Backhaul mode allows wireless clients to connect to the mesh AP 2.4Ghz radio while using 5Ghz radio for the point to point backhaul link.  Can you also connect Wireless clients to the mesh AP in a point to multipoint solution?

Thanks,

http://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/7-4/design/guide/mesh74.pdf

[Leo Laohoo · Accepted solution]

Backhaul is 5 Ghz.  

Wireless clients can connect to 2.4 Ghz.  

[CB90021204]

Thank you