CLI Login CAPWAP accesspoint associated in WLC

[snarayanaraju]

Hello All - How to do CLI Login of CAPWAP Wireless accesspoint that is already associated with a WLC. Though telnet is enabled, when tried login the accesspoint using the IP address of the accesspoint, it prompts for credential, 

default credential "cisco/cisco" or the credential i use for login to WLC doesnt allow me to login the Accesspoint.

Appreciate if you can help me on this 

regards/sairam

[Rasika Nayanajith]

Did you try Cisco/Cisco ?

Rasika

[snarayanaraju]

Thanks Rasika - No it doesnt work. Cisco / Cisco fails

[Rasika Nayanajith · Accepted solution]

Hi

In WLC, select that AP & under credential tab, you can override it. Defined a username, password & enable password & hit apply. Then try to use that newly setup credential for that AP

If you like to change credential for all your APs, you can do that under global configuration in wireless tab

That should work

HTH

Rasika

*** Pls rate all useful responses ***

[snarayanaraju]

Excellent. It worked. 

Thanks again Rasika. You are great