Clients need to move further from AP to connect successfully.

[Stewart Roth]

I have clients using a hand held device that can not connect to a LAP1121G unless they move away from the LWAP.  If they attempt to use it in the office they get no connection.  If i have the user take the device out into the parking lot they connect and all is well.  Problem is they go through a process nightly while the devices are in the office and that process is not completing because of no connectivity. Using WPA-PSK with TKIP Suggestions??

[Saravanan Lakshmanan]

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns779/C96-609146-00_config_best_practices_for_motorola_st.pdf

[Srin_G]

Nice link mate, i was searching for this!

[Saravanan Lakshmanan]

Hi Srini

For this particular post - if you don't rate that's ok, kindly please don't underrate.

Thanks.

[Damon Garner]

You can also extend the timeout value for the M1-4 keys:

config advanced EAP eapol-key-timeout 5000

This will give the handheld a little more time to answer the request.