ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
150
Views
0
Helpful
3
Replies
Highlighted
Beginner

Configuring wireless Bridge on AIR-AP1572EAC-E-K9

I am configuring a wireless Bridge on the AP AIR-AP1572EAC-E-K9. When  I, set the role to non-root on Radio  and enables it,the status says that the software/Hardware is disabled and down and when I change it to Root and enables, the status is enabled and up. It only accepts the role of root bridge. What could be the problem? I have already configured as a root and wanted the other to be the non-root

 

Thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Re: Configuring wireless Bridge on AIR-AP1572EAC-E-K9

You have to select "non-root bridge" option, not just non-root

 

HTH

Rasika

View solution in original post

3 REPLIES 3
Highlighted
VIP Mentor

Re: Configuring wireless Bridge on AIR-AP1572EAC-E-K9

What software version you run on your 1572 ?

 

Here is one of RootBridge/Non root bridge setup I have done with "c1570-k9w7-mx.153-3.JBB4" autonomous image using 1572.

BR01(config-if)#station-role ?
non-root Non-root (bridge)
repeater Repeater access point
root Root access point or bridge
scanner Scanner access point
spectrum Spectrum Only access point
workgroup-bridge Workgroup Bridge


BR01(config-if)#station-role non-root ?
bridge Bridge non-root
wireless-clients Nonroot with Wireless clients
<cr>

 

HTH

Rasika

*** Pls rate all useful responses ***

Highlighted
Beginner

Re: Configuring wireless Bridge on AIR-AP1572EAC-E-K9

The software ver is: 15.3(3)JC

Thanks,
Highlighted
VIP Mentor

Re: Configuring wireless Bridge on AIR-AP1572EAC-E-K9

You have to select "non-root bridge" option, not just non-root

 

HTH

Rasika

View solution in original post

Content for Community-Ad