Controller configuration for AP1242 with single antenna connection

[twikel]

I'm deploying a LWAPP solution over a MobileAccess distributed antenna system (DAS) using AP1242s. the A & B/G antennas are connected to the primary (right side) antenna outputs. The 4404 WLC (wireless->access points->radios->802.11a/n or 802.11b/g/n) has the AP configured with diversity enabled. The AP are installed on shelves in stacks of 4, with very little spacing between the the APs. My question is do I need to set the "diversity" setting to right? If so, what is the easiest way to do that through WCS?

Thanks

Todd

[Scott Fella]

You can create an AP template and push it out the the ap's that need that confgiuration. If you don't have that many, might as well do it from the WLC.