ā06-14-2017 02:49 AM - edited ā07-05-2021 07:12 AM
Hello , I have a question about Cisco Aironet 1852e AP ,
does this AP supports interference detection ?
if it support ,when the AP on a channel with interferences ,
does it change the channel automatically ?
thank you for your answer.
ā06-14-2017 04:07 AM
does this AP supports interference detection ?
CleanAir, by default, is disabled. Enable CleanAir and it will detect inteference.
does it change the channel automatically ?
EDRRM, Event Driven Radio Resource Management, is disabled by default. Enable this allows the AP to change channel when interference is detected to be strong.
ā06-14-2017 08:00 PM
Thank you for your help , I saw the setting step on controller on the Cisco website ( Figure1 and Figure2 ) .
but my AP's GUI does not like that , I found a similar GUI on the Internet ( Figure3 ) .
Does my AP can do the things of interference detection and change channel when the interference is detected to be strong automatically ?
p.s. My AP's firmware type is Mobility Express , version is 8.3.112 , and there is a virtual controller in the AP .
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: