cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

355
Views
5
Helpful
3
Replies
Enthusiast

Enabling BLE radio on a Cisco 4800 AP

Hello,

 

I could not find single consolidated document for Enabling the BLE radio on a 4800 AP.

 

Appreciate if I could please get the responses to below queries:

  1. BLE Manager account not a necessity for enabling the BLE radio on a 4800 AP and can be enabled directly through CMX and WLC?
  2. How do we enable the BLE radio on a 4800 Access Point? (The configuration on WLC & CMX)
  3. How do we configure the BLE beacon profile and from where the “BLE Beacon Profile” needs to be configured (CMX / WLC)?
Everyone's tags (2)
3 REPLIES 3
Hall of Fame Community Legend

Re: Enabling BLE radio on a Cisco 4800 AP

Contact your Cisco AM/SE.
To enable BLE, you'll need access to DNA Spaces or Web CMX.

Enthusiast

Re: Enabling BLE radio on a Cisco 4800 AP

Thanks Leo for your response.

However based off the Cisco WLC 8.8 config guide, DNA Spaces BLE manager account is a requirement only to manage BLE USB dongle.

Could not find in any documentation that the BLE manager account is required even for the BLE radios integrated into APs like 4800 APs.

Do we require BLE manager account even for enabling and configure the BLE profiles for 4800 APs?

Cisco USB BLE beacon.PNG

Everyone's tags (2)
Highlighted
Hall of Fame Community Legend

Re: Enabling BLE radio on a Cisco 4800 AP

Muhammed, contact your Cisco AM/SE.
To enable BLE, you'll need access to DNA Spaces or Web CMX.
That is all I am going to say.
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards