02-05-2015 01:38 AM - edited 07-05-2021 02:26 AM
Hi all,
Perhaps someone here can help me further. I'm trying to configure split tunneling on the wireless controller which is running code 8.0.110.0.
I've followed the config guide. I created the Flexconnect ACL, defined the interesting and bound it to the Flexconnect group. However the interesting traffic is not locally switched. When I tried to do it on a WLC running 7.6.130.0 it is working perfectly.
Did I miss a new parameter, which needs to be defined?
Regards,
Patrick
04-15-2015 05:06 AM
After TAC has been involved it was confirmed to be a bug.
04-15-2015 02:30 PM
Would like to see bug ID information if you have
Rasika
04-22-2015 04:06 AM
Hi Rasika,
The bug is CSCut91036. However the workaround stated does not work, as I have tried reconnecting the client multiple times.
Regards,
Patrick
10-26-2015 02:07 AM
Hi Patrick
Did you find a solution to this. I seem to have the same issue with a teleworker solution. As I understand it this is a new bug in 8.x Would using 7.6 solve it?
Regards Rasmus Sindum
10-27-2015 04:21 AM
Hi Rasmus,
It is working on 7.6. It's beyond me why Cisco decided to terminate this bug as the workaround clearly does not work.
Regards,
Patrick
10-27-2015 05:38 AM
To bad
I'm using a new 5520 controller. No 7.6 software for me.
I might have to run a TAC case on this.
Thanks for following up
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: