04-25-2017 12:21 AM - edited 07-05-2021 06:55 AM
Hi all,
I am writing CLI to block some MAC address.
for example:
access-list 705 deny 7831.c181.d8ff 0000.0000.0000
access-list 705 deny 4404.4470.a7a0 0000.0000.0000
access-list 705 deny c4b3.0118.5258 0000.0000.0000
But I took mistake for a MAC address.
so I want to delete a access-list 705 deny 7831.c181.d8ff 0000.0000.0000
It is as below right ? CLI:
no access-list 705 deny 7831.c181.d8ff 0000.0000.0000
I am not use because when I do like this.
All MAC address was deleted.
I cannot see any MAC address as show access-list 705
so my question is that, How to delete only one MAC address that still keep other MAC address.
Thanks
04-25-2017 12:55 AM
just use this command:
no access-list 705 deny 7831.c181.d8ff 0000.0000.0000
Regards
Dont forget to rate helpful posts
04-25-2017 01:05 AM
04-25-2017 01:22 AM
Yes.. there is a limitation using CLI to create and remove the Access-list with same number.
Better to use diff access-list <705/706> numbers.
example:
access-list 705 permit ab1d.e08d.1103 0000.0000.0000
access-list 705 permit 5h59.4835.3b83 0000.0000.0000
access-list 706 permit cd1f.e10e.b422 0000.0000.0000
access-list 706 permit 78e4.0038.7e45 0000.0000.0000
access-list 706 permit ef1b.7745.c576 0000.0000.0000
Regards
Dont forget to rate helpful posts
04-25-2017 03:35 AM
Hi
another issue.
do you have any link related CLI for AP cisco ?
04-25-2017 03:39 AM
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116582-configure-ap-00.html
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap16-filters.html
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: