how to pull out the flexconnect configuration of all the flex ap's at once from the controller

[atifali.zaidi1]

Hello Experts,

in one of my upcoming implementations , i have to centrally switch a wlan which is currently distributed to "flexconnect" ap's with vlan mappings.

there are like 150+ flex ap's with different vlan mappings, so if i have to roll back then it will be tough job to remember the vlan mappings.  now i know that  "show ap config general <cisco ap name>" could be used to get that info for a particular ap but the situation where i have 150+ flex ap's , is there any script which could be used to get info of all the flex ap's at once from the controller ?

[Flavio Miranda]

Hi,

 I sent to you a script I wrote and do exactly what you need. Just change IP address, username and password. This script run in Linux machine, you just need to install Expect on it. Usually, Linux support Expect by default.

-If I helped you somehow, please, rate it as useful.-