cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
61446
Views
105
Helpful
7
Replies
Highlighted
Beginner

How to restore the factory settings

The ap 3502i has been registered to the wireless controller, but now want to restore the factory settings, repeated after the upgrade or will appear before the registration information of the wireless controller, the problem how to solve

thanks

Everyone's tags (1)
7 REPLIES 7
Hall of Fame Master

Re: How to restore the factory settings

If the AP is joined to the wlc, you can reset the ap to factory default from the GUI or CLI. If you have the AP in front of you with a console cable, you can login to the AP using Cisco/Cisco unless you changed it when it was joined to the wlc. Type the following:

debug capwap console cli

erase /all nvram:

undebug all

reload

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Beginner

Re: How to restore the factory settings

Supper
Beginner

Re: How to restore the factory settings

It is work

How to restore the factory settings

Two other ways besides what scott metnioned:

1. Through the MODE button:

- Power off the AP.

- While keeping the MODE button pressed, power on the AP.

- Still keep the MODE button pressed until the Status LED turns to red and then release it:

2. Via installing the recovery image:

- Download the recovery image for 3500 from Cisco site.

- on AP Console write the command "Debug capwap console cli".

- Then write the commadn "Archive download-sw /overwrite /reload tftp:///"

Reference: https://supportforums.cisco.com/docs/DOC-18208
(question 10).

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"
Hall of Fame Community Legend

How to restore the factory settings

Console into the WAP and in enable mode, enter the command:  clear capwap private

Beginner

FYI - None of these solutions

FYI - None of these solutions actually clear out any statically assigned IP settings on the AP.  (IP, Subnet, Gateway.)  I have yet to find a solution that does...

Cisco Employee

If you want to reset the

If you want to reset the access point to its default settings and a static IP address, use the write erase or erase /all nvram command. If you want to erase everything including the static IP address, in addition to the above commands, use the erase and erase boot static-ipaddr static-ipmask command.

 

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-4_10b_JA/configuration/guide/scg12410b/scg12410b-chap4-first.html#wp1183709

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards