cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

205
Views
0
Helpful
1
Replies
Beginner

IP or MAC Filter on 1522 AP

Dear friends,

I have a wireless sytem with a WLC 4400 and several 1522 Access Points. They don't actually function as Access Points because I'm using radio communication only for backhaul. There are no clients connected to the Access Points. All traffic on the network comes from the devices connected on the LANs that are bridged through the APs ethernet port.

I would like to create filters to allow only certain devices to be able to transmit over the radio link. I've used this in the past on 1310 units and it was very easy to do via GUI. This filter could be either by IP or MAC Addresses. IP would be better for me.

I've looked for this on all related documentation, but found nothing.

Is this possible to be done with these models? How?

Any help is appreciated.

Thank you.

1 REPLY 1
Highlighted

Re: IP or MAC Filter on 1522 AP

The WLC doesn't have the acl 700 like functionality. When we do Mac filtering its either to allow/disallow traffic on the WLAN.

Best bet would be to do acl on the switches and block the Mac there vs at the WLC level

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards