What are the configuration required on ISE to integrate with Prime 126.96.36.199?
On PI side, I have added ISE in the below path
Design-> External Management Servers -> ISE Servers.
Apart from this anything else to be done on PI..?
Thanks in advance.
Solved! Go to Solution.
The stuff to do on the ISE is set up as a Radius Server for your client authentication. When ISE acts as a radius server, Prime Infrastructure collects additional information about these clients from Cisco ISE and provides all client relevant information to be visible in a single console on PI.
The point to remember is that PI is a management sloution for wired and wireless clients, while ISE acts as ACS and NAC combined. Recall that ACS on its own could not do posture validation without NAC.
Prasan I also added ISE on prime and it is strange I dont see any change
Have you got additional information on client device from ISE ?
Have you done some thing else from the ISE ?
There is no additional configuration required on Prime. Its like if you add ISE in prime, then you will be able to get information about clients(authentication logs) directly from prime.