Hi every one, i have a DEMO of Mesh with a 2504 on 7.6 code with 3 1550 the infrastructure works fine on many ways but when i try to connect the cam with the repeater the WLC see one MAC with 2 IPs one of the cam and one of the repeater so the link between the cam and de MESH infrastructure its flapping and dosen`t work.
Anyones know what can i do to support this scenario?
what are you using as the repeater?
for a deployment like yours i would recommend having the camera behind a WGB or a MESH AP with the camera plugged into the ethernet port of the wireless MESH AP.
Hi Viten, this is my as under the sleeve if all fails, hope the solution of Stephen works if is not, i will propose that.
sounds like you may need to disable the IP Mac binding on the WLC.
config network ip-mac-binding disable
Im applied the follow configurations:
1.- disable ip-mac-binding
2.- disable on 2.4ghz coverage hole detection and change of -75 to -72 db the roaming umbral to perform tuning on roaming behavior
3.- disable low data rates on 2.4 to force better troughtput and low distance between the CAM and the MESH AP
4.- Enable all video stream work around on 2.4ghz and 5ghz
5.- Apply Platinum QoS on the SSID for video
6.- Force to custom DCA and TPC on 2.4 to improve the performance of the cam and avoid disconnection
Make some test and all works fine but sometimes the cam change of AP or randomly drops some pings and for this stop transmitting image to the web interface... Any idea what can i do to improve this?