We have a number of sites where we have Cisco 21006 Wireless Controllers and a number of 1131 LAP's attached to them.
The units are located on the same physical LAN segment as the WAP's and they are connected directly to the controller.
Over the past three weeks we have had a number of controllers fail by locking up and constantly rebooting.
When on the console of the WLC before it reboots there is an error message that says "Watchdog process has intiated reaper as process cannot be contacted." then the next message starts "Reaper cleanup started..." and the unit reboots.
No configuration changes have taken place on the WLC's over the past few weeks and no additional kit hsa been installed.
This tool is essentially used to generate basic and best practice configurations for the 9800 Controller. The basic configurations include Day 0 Config, Central and Local Webauth, Dot1x, PSK etc. The tool uses a GUI format to take input variables for the ...
The Workplace, Reimagined: Secure Network Solutions for Business Resiliency
Network Insider Live Webinar
Tuesday, August 18, 202010:00 am Pacific Time(San Francisco, GMT-08:00)
Where and how your employees work is changing—your workforce can...
Do you have hands-on experience with wireless network management?
If yes, please participate in this quick online survey. We'd like to understand your wireless network management and job roles that partake in this task. Your feedback will be reviewed a...
This event had place on Thursday 11, June 2020 at 10hrs PDT
In this session, the Cisco expert covered single image orchestration changes with the Cisco IOS XE Software Release 17.2.1r for Cisco IOS XE and Cisco IOS XE SD-WAN use cases. Duri...
This is a two-step process.
Step 1: Need to add the FlexConnect AP to a FlexConnect Group.Step 2: Need to configure a FlexConnect ACL (to specify the local traffic-of-interest), and map it to that FlexConnect Group.
For step 1----------As in the i...