07-10-2012 10:33 AM - edited 07-03-2021 10:23 PM
I created a LAP Template in NCS to configure some new 1142 LAPs that were installed in a remote office. These LAPs need to be in FlexConnect mode with VLAN support. The template is being applied with partial success on every access point. Details of the partial success say the FlexConnect Parameters fail with the following error.
Provision Failure: com.cisco.wnbu.server.common.errors.ObjectNotFoundException cannot be cast to com.cisco.wnbu.server.common.errors.InternalException
Am I doing something wrong?
The FlexConnect portion of the template has VLAN Support enabled, Native VLAN ID, and the Profile Name-VLAN Mappings configured.
Prime NCS version 1.1.1.24
Access Points are AIR-LAP1142N-A-K9s running 7.2.110.0
07-10-2012 11:33 AM
Jason:
Is it mentioned anywhere that it is "partially" succeeded?
As i see from the message it is failed!
Sent from Cisco Technical Support iPad App
07-10-2012 12:04 PM
Can you offer any insight as to why it failed?
01-07-2013 10:44 PM
Any updates to share in this case?
.......
Solution:
Make one template just to reconfigure the AP to Flexconnect without settings, apply and reboot. Then to make another template which do the FlexConnect settings you want to add. Can not be done with just one template...(as far as I know)
Because the FlexConnect-settings cant be applied if the AP isnt a FlexConnect already.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide