cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
975
Views
0
Helpful
4
Replies

Limiting client on AP

andrie prabudhi
Level 1
Level 1

Hi,

Is there a way for me to limit 20-25 user per AP in the WLC?

on this pic below  I already configure maximum allowed client per AP radio  :

max allow per client.jpg

for the info my sofware version WLC is :

Software Version7.3.101.0

and use cisco AP 3600 : AIR-CAP3602E-C-K9  

but on pic below the AP still get more than 24 users,

max allow per client2.jpg

is that affect when i configure the radio global parameter like on pic below :

invalid license3.jpg

please help me with this issue ..

thanks in advance

--

Andrie

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

There was a bug id to add this as a feature

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtj94508

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

View solution in original post

4 Replies 4

Scott Fella
Hall of Fame
Hall of Fame

Currently there is no limiting on client count per AP. As you already know, you can limit the number of clients either globally on the WLAN or on a per radio. You might want to maybe say 15 per radio so that gives you some 802.11bgn clients in case some devices are only 2.4ghz.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Scott Fella
Hall of Fame
Hall of Fame

There was a bug id to add this as a feature

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtj94508

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

so, what can i do?

i'm still facing slow connection for 2.4ghz freq if the clients on 1 AP more than 24

i already disable data rate for protocol 802.11b and set the global tcp mss to 1300

thanks

You need to perform some testing and try to pin point the issue. Upgrade the drivers, find out for yourself what issues are actually happening that you see and not what is being told to you. Maybe post your show run-config so we can review your config and also let us know if its a single SSID or all.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: