Hello,
My customer has a traditional guest access desgin with foreign and anchor WLC without an ISE.
It works fine.
Now he plans to install a new WLC5508 for remote offices.
All APs in these remote offices will be in FlexConnect mode connected to the central WLC which is also an foreign WLC.
The guest traffic is central switched and corporate SSIDs will be local switched.
Now our problem is, is it possible to limit the guest bandwidth on each remote office with different values?
Example:
Office 1: Guest Bandwidth should be 1000k
Office 2: Guest Bandwidth should be 2000k
and so on....
All APs in remote office 1 will be in FlexConnect Group 1 and the APs in remote office 2 in FlexConnect 2.
Further I will create AP Groups for each remote office and add the belonging APs to this AP Group.
Then I will create "local policies" and map the decided policy in AP group to the Guest SSID.
So my question is; is this supported and does it work?
I've read the config guide for 8.0 and didn't find anything about FlexConnect and local policies, I mean there are no Restrictions for Local Policy Classification
Or is there another option available?
thanks
Martin
