MERAKI POINT TO POINT BRIDGE MODE

[pramod]

i would like to create point to point bridge using meraki access point. I want to carry vlan 10 from one end of the switch to the other end of switch via AP1 and AP2 resp. How to achieve this, please help with configuration

[Brandon Svec]

You know Meraki offers free phone and online support, right?  In your dashboard just navigate to help > get help.

That said, you should find this helpful:

https://kb.meraki.com/knowledge_base/extending-the-lan-multiple-repeaters-and-wired-clients

-- please remember to rate and mark answered helpful posts --

[kaaftab]

check the link given below for different configurations

https://meraki.cisco.com/lib/pdf/meraki_whitepaper_point_to_point.pdf

[Sven Kutzer]

Meraki Access Points automatically MESH between each AP in the same Network.

So just add the two APs in the same Network in your Dashboard and thats it.

Please feel free to contact me,

if you have any further questions!

Regards,

Sven

[abwahid]

Hi,

Configure one of your AP in NAT Mode/Gateway mode and to 2nd in Repeater mode and then connect Repeater AP with the SSID of Gateway AP.

By this configuration both AP would establish point to point wireless link between them to carry vlan 10 traffic.